Requirements For New Metes and Bounds Descriptions and Plats Of Survey.
All new surveys, metes and bounds descriptions, and plats of survey not previously recorded, must be prepared by a registered Professional Surveyor and must be in compliance with the Ohio Administrative Code, Chapter 4733-37.
Checked items will be required to be revised by the Professional Surveyor.
APPROVED ROAD INTERSECTION MONUMENTS
Last revised 7/12/05
*subject to change without notice
INTERSECTION:
CR30 Delmont Rd/CR57 Crumley Rd
INTERSECTION: CR30 Delmont Rd/CR57 Crumley Rd
TOWNSHIP: Hocking
MONUMENT: 5/8" Rebar
PLAN REFERENCE: CR30-HOC38 Bridge Plan 2005
TWP: 14
RANGE: 19
SECTION: 8,9,16,17
MONUMENT ON: Common Corner
REFERENCE TO: N/A
INTERSECTION:
CR31 Coonpath Rd/Maradon Ct.
INTERSECTION: CR31 Coonpath Rd/Maradon Ct.
TOWNSHIP: Pleasant
MONUMENT: 3/4" Steel Rod
PLAN REFERENCE: CR31 Road R/W Plans 2000
TWP: 15
RANGE: 18
SECTION: 17,20
MONUMENT ON: N/A
REFERENCE TO: NW CR, NE QTR, SEC 20
INTERSECTION:
CR31 Coonpath Rd/S.R. 188
INTERSECTION: CR31 Coonpath Rd/S.R. 188
Lancaster-Thornville Rd
TOWNSHIP: Pleasant
MONUMENT: 3/4" Steel Rod
PLAN REFERENCE: CR31 Road R/W Plans 2000
TWP: 15
RANGE: 18
SECTION: 16,21
MONUMENT ON: N/A
REFERENCE TO: Common Corner 15,16,21,22
INTERSECTION:
CR31 Coonpath Rd/TWP1339 Susalou Ct
INTERSECTION: CR31 Coonpath Rd/TWP1339 Susalou Ct
TOWNSHIP: Pleasant
MONUMENT: 3/4" Steel Rod
PLAN REFERENCE: CR31 Road R/W Plans 2000
TWP: 15
RANGE: 18
SECTION: 17,20
MONUMENT ON: N/A
REFERENCE TO: NW CR, NE QTR, SEC 20
INTERSECTION:
CR31 Coonpath Rd/TWP427
INTERSECTION: CR31 Coonpath Rd/TWP427
Old Millersport Rd
TOWNSHIP: Pleasant
MONUMENT: 3/4" Steel Rod
PLAN REFERENCE: CR31 Road R/W Plans 2000
TWP: 15
RANGE: 18
SECTION: 16,17,20,21
MONUMENT ON: Common Corner
REFERENCE TO: N/A
Only monuments on the above list are approved road intersection monuments which can be referenced, as a point of beginning, on a new survey. A monument at a road intersection may be added to this list if it is referenced to a section corner or section 1/4 corner, is shown on a centerline plat on file at the Fairfield County Engineer's Office, and is approved by the County Engineer.
